This amp is similar to T1, but uses the high power sta516 output stage chip to generate 2 x 180W @ 8 ohm. The T4 has two channels and is suitable for 8 ohm loads. It can drive 4 ohm, but with around 90W power output. For 4 ohm loads we recommend the T2/T3S amp instead.
The T4 uses audiophile Jantzen input capacitors.
It can take both AC and DC voltage inputs. It also have an PWM digital input which means it could be connected to digital out of the DDX amplifier for example or another amp with PWM output.
*180W+180W output @8ohm.
*Speaker protection: DC/error and power on delay, power down immediately off (when transformer powered.
*Power down interface to switch or controller: It can be remotely switched off from compatible preamp or controller
*Input sensitivity for full power 1.5V
*2nd PWM signal input.
*High-level design and good parts used.
190*102mm. New version 2016: 100*160mm
*Inputs: 2.54mm connectors for signal, 7.62mm connector for power supply
*Outputs: 7.62mm connectors
*Power supply: Dual AC; AC34V-0-34V (30 - 34 is ok) or single DC 36 - 48V. Will draw around 8.5A @ 48VDC. If using 4 ohm speakers recommened PSU is AC28V-0-28V or single DC 39V.