Hifimediy T2 Jantzen

Hifimediy T2 Jantzen
Views: 104108 Product Code: 10000003
Availability: In Stock
Qty: Add to Cart

TK2050 is the chipset consisting of the TC2000 controller and the TP2050/STA510 output stage chip. Our T2 amp uses an upgraded output stage chip, STA510A together with the TC2000 controller. This makes it more powerful and better at lower impedances, whle keeping the great sound signature of the TK2050 which is mainly from the TC2000 controller.

The T2 utilizes one STA510A output stage chip for each channel in paralleled configuration. This amp can drive any speaker from 4-8 ohm. It is recommended for speakers in the 4 ohm range. For 8 ohm speakers, we recommend the T1 amp. 
The input capactiros are quite important for the sound quality of this kind of amps, as it's one of the few parts that the audio signal flows through. 
The new batch uses audiophile Jantzen incput caps (Jantzen Cross Caps 2.2uf)

Power requirement:
It can run on either AC or DC powersupply. DC range is 22V - 31V, AC range is 16V - 22V.
The new batch (Dec 2014) will use 3900uf PSU caps, which is good for DC, but a little low for using AC. We recommend using 24V -28V DC.
Additional info
Important about tripath amps: Ground on the two channels can not be connected together.
It is ok to only connect 1 speaker and leave the other channel unconnected if desired.
The board can not be bridged to make 200W mono.
  • 10000uf Nichicon KG cap New batch december 2014 uses 3900uf Nichicon KG caps
  • 2*100W@4ohm, 2*50W@8ohm
  • Power input: DC 22V-31V or AC 16V-22V
  • TC2000 controller and two sta510 power stage chip.
  • On/off relay, preventing "pop" sound in speakers during on/off
  • Input impedance: 50K. (20K if you remove the vol.pot)
  • Input sensitivity for full power: 1.5V RMS
  • Onboard volume pot
  • Dimensions: 128x81x38mm
  • PCB thickness 2mm
  • Comes fully assembled, as pictured.
  • Quality MKP input 3.3uf input caps
  • All caps and parts are well known brands
  • Big fanless heatsink.
Part brands might change slightly between batches because of availbility.
5 ( 5 / 5 )
This is a must have amplifier. It will outperform amplifiers that cost more than 500 euros. It is on my system for more than a year now. Many times i use this one instead of my audiolab power amps.

Write a review

Your Name:

We do not moderate any reviews except those postings that are clearly not reviews. Questions or comments that are not reviews might be deleted. If you have a question, please contact us. Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below:

Input: 230VAC output: 28V DC (+-10%) Dimensions: 100x100x40mm   The connexelectronic sm..

TK2050 is the chipset consisting of the TC2000 controller and the TP2050/STA510 output sta..
1 reviews

We made this lower powered Tk2050 to be in the same category as the TA2020 and TA2022 because we thi..
6 reviews

Without MCAP (pictures does shows the mcaps - this price is without mcaps) TK2050 is the chi..
1 reviews

Our original and bestselling USB DAC with Sabre ES9023 DAC chip, Savitech SA9023 USB receiver. ..
$42.00 $29.99
43 reviews

The Hifimediy USB isolator is used to prevent ground loop noises and increase sound quality. It work..
24 reviews

This model is discountinued. Look at the 9018 model instead:
43 reviews

Best portable DAC in Norwegian newspaper VG! 6 stars and best portable DAC of the Year in Lyd og Bil..
39 reviews

US :